Voxelane Start a project

Logistics & manufacturing

Overhead and gantry crane training

Bridge, gantry and pendant-controlled cranes in a model of your workshop or yard. Operators practise pre-use checks, slinging and lifts through a busy floor.

Built as
XR · VR · Simulator · Web
Around
Your site and crews
Starts with
A pilot
A scene from a 3D crane simulation: an operator with a pendant control walks a steel beam down a workshop bay on an overhead crane while a forklift crosses ahead

What is overhead crane simulator training?

Overhead crane simulator training lets operators run a virtual bridge or gantry crane from a real pendant, radio remote or cab, in a model of their own workshop or in mixed reality on the actual floor. They practise pre-use checks, slinging, travelling a load through a busy floor and stopping a swinging load, all scored, without taking the real crane out of production.

Overhead cranes are often run by people whose main job is something else: fitters, welders and storemen who lift a few times a shift. Refresher training is hard to fit in, and bad habits are easy to keep.

A short mixed reality or VR session at the start of a shift covers the pre-use check, the sling choice and the travel path through your own floor, and shows the instructor exactly who needs more time.

Scenarios we can build

Examples only. We rebuild each one around your site, equipment and procedures.

Pre-use inspection

Find the faults planted on the crane: a worn hook latch, a damaged sling, a limit that doesn't trip.

Travelling a load through a busy bay

Move a load the length of the workshop while people and forklifts cross the path.

Stopping a swinging load

Bring a load to rest after a hard start using the controls, not hands.

What we can measure

Every session can be scored against your own checklist and exported to your LMS or as PDF.

Built for

  • Workshop and fabrication staff
  • Warehouse staff
  • Maintenance fitters
  • New starters

Rules and standards

In Australia, bridge and gantry cranes controlled from a cabin, or remotely with more than three powered operations, need a CB licence. Pendant-controlled cranes generally don't, but their operators must still be trained and competent. We build to whichever applies on your floor.

  • Faults found in the pre-use checkEach planted fault spotted, missed or reported.
  • Load swing during travelPeak and average swing from pick-up to set-down.
  • Clearance from peopleClosest distance between the load and anyone on the floor.

Scope your build

A first call about what your people face, then an outline of the scenarios, the format and the scoring we would build.

Start a project
Next in Logistics & manufacturingPort & container cranes →

Frequently asked questions

What is overhead crane simulator training?

Overhead crane simulator training lets operators run a virtual bridge or gantry crane from a real pendant, radio remote or cab, in a model of their own workshop or in mixed reality on the actual floor. They practise pre-use checks, slinging, travelling a load through a busy floor and stopping a swinging load, all scored, without taking the real crane out of production.

Can we use our own pendant layout?

Yes. We can fit a replica pendant or radio remote so the buttons match the crane on your floor.

How long is a session?

We usually design modules of 15 to 30 minutes, so they fit into a toolbox talk or the start of a shift.

Can you model our workshop?

Yes. We rebuild the bay from drawings or a laser scan, including your crane, racking, walkways and exclusion zones.